Potential use of corn leaf waste for biofuel production in Jordan (physio-chemical study) was written by Amer, Mohammad W.;Aljariri Alhesan, Jameel S.;Ibrahim, Sawsan;Qussay, Ghadeer;Marshall, Marc;Al-Ayed, Omar S.. And the article was included in Energy (Oxford, United Kingdom) in 2021.Recommanded Product: 4-Hydroxy-3-methoxyphenethanol The following contents are mentioned in the article:
The increase in energy demand, especially in Jordan, has encouraged researchers to consider alternative sources of energy, such as biofuel production from agricultural waste. For this study, Jordanian corn leaf waste was characterized by ultimate and proximate anal., TGA, FTIR and solid state 13C NMR. The waste showed high volatile matter, high at. H/C ratio and high O content. The corn leaf waste contained 32.1 wt% cellulose, 18.1 wt% hemicelluloses and 11.9 wt% lignin. The FTIR and 13C NMR spectrums showed high concentrations of aliphatic and carbonyl carbon. The corn leaf waste was pyrolyzed in a temperature range of 300-450°C under a constant flow rate of nitrogen. Higher oil yield was obtained at pyrolysis temperature of 450°C. The gas yield and higher heating value of the product increased as the temperature increased, whereas the water content decreased. The biofuels were rich in carbon and had a high oxygen content, which decreased as the temperature increased. The 1H NMR confirmed the markedly aliphatic character of the biofuel. The GC-MS for the biofuel indicated the presence of hydrocarbon series, large amounts of oxygenated compounds and a few nitrogen and sulfur compounds The simulated distillation showed a high proportion of diesel fraction (57-73%). This study involved multiple reactions and reactants, such as 4-Hydroxy-3-methoxyphenethanol (cas: 2380-78-1Recommanded Product: 4-Hydroxy-3-methoxyphenethanol).
4-Hydroxy-3-methoxyphenethanol (cas: 2380-78-1) belongs to ethers. Esters perform as high-grade solvents for a broad array of plastics, plasticizers, resins, and lacquers, and are one of the largest classes of synthetic lubricants on the commercial market. Polyesters are important plastics, with monomers linked by ester moieties. Esters contain a carbonyl center, which gives rise to 120° C–C–O and O–C–O angles. Unlike amides, esters are structurally flexible functional groups because rotation about the C–O–C bonds has a low barrier. Their flexibility and low polarity is manifested in their physical properties; they tend to be less rigid (lower melting point) and more volatile (lower boiling point) than the corresponding amides. Recommanded Product: 4-Hydroxy-3-methoxyphenethanol
Referemce:
Ether – Wikipedia,
Ether | (C2H5)2O – PubChem